Oil pipe for w2000

Post Reply
Ageing Rotarian
moderator
Posts: 59
Joined: Fri Sep 19, 2014 9:43 pm

Oil pipe for w2000

Post by Ageing Rotarian »

Dear all, can anyone recommend a suitable oil pipe which is suitably thin walled to be contoured to enable the side cover to be fitted but is heat resistant enough to connect to the inlet manifold on a W2000 with oil tank?
I will try and add some pictures later. The existing pipe is a mishmash of old and new pipes with copper connectors which leaked like sieve. Most of the hose ends/connectors are 5mm and the od of the pipe which runs close to the casing is about 8 to 9mm OD.
Lots of pipe out there, but struggling a little as some are too large on the od or too rigid that it kinks when you try and manipulate it.
As usual gents any assistance would be appreciated.
Regards
Roy
Post Reply