Hi me again, the demonstrator is "fighting back" but progress is being made.
Can anyone help with the thread type and sizes for each brake master cylinder, can't find it in the manual?
My new coils will not fit where Norton planned, any suggestions?
Many thanks Roger
Brake union thread & sizes
-
johnbirchjar
- moderator
- Posts: 1659
- Joined: Sat Mar 07, 2009 11:20 pm
Re: Brake union thread & sizes
Is your "Demonstrator" air or water cooled?J.B.
-
Rotating588
- moderator
- Posts: 42
- Joined: Sun Jun 21, 2020 12:46 pm
Re: Brake union thread & sizes
Air cooled.
-
johnbirchjar
- moderator
- Posts: 1659
- Joined: Sat Mar 07, 2009 11:20 pm
Re: Brake union thread & sizes
Is it an old IP2 frame?if so,(if they are the same as a Classic 
) the coils should fit on the front of the frame, attached to the back of the engine air filter cover,(the coils have their own special little brackets 
)J.B.
) the coils should fit on the front of the frame, attached to the back of the engine air filter cover,(the coils have their own special little brackets )J.B.