Commander end plates, moly'd

Post Reply
User avatar
Richard Negus
moderator
Posts: 966
Joined: Mon Jun 18, 2007 5:11 pm
Location: Wilds of Lincolnshire

Commander end plates, moly'd

Post by Richard Negus » Mon May 27, 2019 4:38 pm

I have a very good pair of Commander end plates which I had moly'd some three years ago and haven't had a job that needed them.
The molying was their first re-grind from original and all the joint faces and threads are excellent.
I don't, unfortunately, have a centre plate to make a full set.
RH plate_1.jpg
RH plate_2.jpg
LH plate_1.jpg
Would anyone like to make me an offer, for either or both, that I can't refuse?
R.
You do not have the required permissions to view the files attached to this post.
Slower slower, no faster faster - the joys of old fogey mode to hooligan mode at the flick of a switch

Post Reply