IP2 harness routing

Post Reply
gripper
moderator
Posts: 422
Joined: Sun Jan 11, 2009 9:05 pm

IP2 harness routing

Post by gripper »

I'm trying to free up an inch or so of extra play in the after-market wiring harness on my IP2. At present the main harness runs along the LH side of the spine and below the petrol tank mount. Things are a bit stretched on full RH lock. It's a tight squeeze under there but I'm going to try and route it above the tank mount i.e. more of a straight line. Has anybody done this? I don't think it's an issue on Classic models as there may be more clearance between tank and frame.ThanksDave
gripper
moderator
Posts: 422
Joined: Sun Jan 11, 2009 9:05 pm

Re: IP2 harness routing

Post by gripper »

Please ignore this thread as, having had a closer look, there is no scope for anything going above the tank mounts.
Post Reply